MarlinFirmwares

This Repo contains various configurations and compiled bin for Creality Printers.

Folder Structure

• PrinterModel
  • Marlin Version
    • Board Version
      • ABL
        • Config Files
        • Compiled Bin
      • Stock
        • Config Files
        • Compiled Bin

Features

Over the baseline Marlin Project following Features are enabled.

• Enabled BLTouch (optional bin)
• Enabled Babystepping, set steps to 0.05mm on Z axis
• Enabled Bed Tramming, including Level Center

How to compile Marlin 2?

Follow this video on walk through on how to compile Marlin 2.

How to Update Firmware?

• Prepare SD Card by formatting the SD Card with Filesystem = FAT32 and Allocation Size = "4096 bytes".
• Copy the copiled/downloaded bin file in SD Card.
• Turn Off the Printer
• Put SD Card in Printer
• Turn the Printer on, it will take a minute or 2 to update
• When the printer re-starts, it may ask to reset the EEPROM settings. Remove the sd card and select reset. The printer may restart and ask again, select reset again.
• If on re-start, the printer does not ask to reset EEPROM, go to Configuration > Advance Setting and select Initialize EEPROM. This will reset the configurations.