address feedback from allen baum on mailing list dated oct 29, 2024

Signed-off-by: Ravi Sahita <[email protected]>

chapter2.adoc

@@ -5,7 +5,7 @@ The following normative architecture extensions are defined.
 
 * `Smsdid` (<<Smsdid>>) - An interface to program the active supervisor domain
 under which a hart is operating. This is a dynamic control state on the hart
-that can be held in an M-mode CSR and modifiable by the RDSM via CSR r/w
+that is held in an M-mode CSR and modifiable by the RDSM via CSR r/w
 instructions  - herewith called the `supervisor domain identifier` assigned to
 the hart. The SDID is a local identifier for the hart and may be used to tag
 hart-local resources to access-control data associated with the supervisor

chapter3.adoc

@@ -109,7 +109,8 @@ addresses with RWX permissions per page
 
 Implementations are not required to support all defined `MODE` settings when
 `XLEN=64`. A write to `mmpt` with an unsupported `MODE` value is not ignored.
-Instead, the fields of `mmpt` are `WARL` in the normal way, when so indicated.
+Instead, the fields of `mmpt` are `WARL` in the normal way, when so indicated
+in <<sdid-32>> and <<sdid-64>>.
 
 The `mmpt.PPN` refers to an `MPTL3` table or an `MPTL2` table based on physical
 address width (`PAW`). For 56 >= `PAW` > 46, `MPTL3` table must be of size
@@ -196,9 +197,9 @@ domain access-permissions with current execution.
 `MFENCE.SPA` is only valid in M-mode. If operand rs1≠x0, it
 specifies a single physical address, and if rs2≠x0, it specifies a single SDID.
 
-If rs1 corresponds to an `MPT_L1_DIR` mapping, the fence applies to
-a 4 KiB page. If rs1 corresponds to a `2M_PAGES` or `4M_PAGES` mapping,
-the fence applies to a 2 MiB or 4 MiB range. If rs1 corresponds to one
+If the contents of rs1 corresponds to an `MPT_L1_DIR` mapping, the fence applies to
+a 4 KiB page. If the contents of rs1 corresponds to a `2M_PAGES` or `4M_PAGES` mapping,
+the fence applies to a 2 MiB or 4 MiB range. If the contents of rs1 corresponds to one
 of the 1G_* mappings, the fence applies to a 1 GiB range.
 
 The behavior of `MFENCE.SPA` depends on rs1 and rs2 as follows:

chapter4.adoc

@@ -41,7 +41,7 @@ address (SPA) is used to index into the `MPT` structure in memory to lookup
 access permissions for the supervisor domain specified via the MPT structures.
 Intermediate `MPTL3` and `MPTL2` non-leaf entries are used to allow this
 structure to be sparsely populated. The `MPTL3` table is not applicable for
-physical address widths <= 46.
+physical address widths \<= 46.
 
 [caption="Figure {counter:image}: ", reftext="Figure {image}"]
 [title= "`MPT` walk for RV64", id=mpt-map-rv64]